Open Pharmaceutical Sciences Journal
2017, 4 : 32-42Published online 2017 April 28. DOI: 10.2174/1874844901704010032
Publisher ID: PHARMSCI-4-32
RESEARCH ARTICLE
High Performance Liquid Chromatography (HPLC) Stability Indicating Method for the Determination of Bromazepam its Copper (II) Chelates
* Address correspondence to this author at the Department of Chemical and Forensic Sciences; College of Science, Botswana International University of Science and Technology, Palapye, Plot 10071, Private Bag 16, Botswana; Tel: +26777424353; Fax: +267-4900102; E-mails: , alulam@biust.ac.bw
ABSTRACT
Introduction:
Bromazepam is hydrolyzed in acidic aqueous solution leading to a series of degradation products. The rate of acidic hydrolysis is believed to be dependent on the state of protonation of the pyridyl and azomethine nitrogen atoms. Stability test is important in pharmaceutical industry to provide evidence on how the quality of an active substance or pharmaceutical product varies with time under the influence of a variety of environmental factors.
Objective:
The aim of the study was to develop a simple stability indicating method for the determination of bromazepam.
Method:
Bromazepam solution was prepared and forced degradation of bromazepam was performed under acid hydrolysis using sulphuric acid. High performance liquid chromatography determination of pure and degraded bromazepam and bromazepam-copper (II) complex was performed using reversed phase octyl C-8 column under isocratic conditions and the chromatographic conditions were set as follows; the flow rate of the mobile phase was 1.5 mL/min; injection volume was 10 μL, column temperature was 30oC and the detector wavelength being 309 nm.
Results:
Bromazepam, its degradation product and bromazepam chelated with copper (II) were determined using the developed mobile phase with flow rate of 1.5 mL/min. Good separation with sharp peak, minimum tailing and retention time repeatability was obtained. The rate order, rate constant and half-life of degradation were also determined, and it was observed that the degradation reaction follows the first order kinetics.
Conclusion:
Chromatographic separation of bromazepam chelated with copper (II) was achieved and the method can be further used in drug manufacturing quality control.